Face off!
alt text
A old stereo receiver/amplifier sits on a worktable. The face plate is off, the lights are dim or out, and interior is caked with dust. But for the patient, possibility awaits.
I was gifted an old Marantz 2230 by a relative who was decluttering their life. When I picked my jaw up off the floor and stopped hugging them, I drug it down to my secret basement lair to revitalize the old girl. As you can see, she's a bit scruffy, but part of the splendid reputation these old beasts carry, is due to their robust internals and ease of repair.
A little spitz of de-oxit, a dash of WD, and a hit of Simple Green and she sang as clear as a mountain stream through my Seinheiser headphones. I'm gonna replace a few electrical bits and bobs and give her a spit and polish and a place of pride where my Marantz 2220B, currently sits*. and soak in that sound of bliss. After pics to come...
*Don't worry, the 2220B will go to a new loving home, I'm not a hoarder, I just enable them.
A little spitz of de-oxit, a dash of WD, and a hit of Simple Green and she sang as clear as a mountain stream through my Seinheiser headphones. I'm gonna replace a few electrical bits and bobs and give her a spit and polish and a place of pride where my Marantz 2220B, currently sits*. and soak in that sound of bliss. After pics to come...
*Don't worry, the 2220B will go to a new loving home, I'm not a hoarder, I just enable them.
The downsides can be pretty severe. A lot of electronic components aren't made, haven't been made in decades -- if a power transistor dies, it's a doorstop. Even some resistors and other basic components that were common commodities a dozen years ago aren't made any more.* And honestly with modern speakers most vintage receivers are ridiculously overpowered, and their architecture makes them big energy-guzzling space heaters.
*I've seen people in the industry say that various pro audio and consumer audio companies have been frantically hoarding things like resistors and diodes in the past couple years because the component manufacturers have effectively obsoleted all through-hole components.